Comparison of Proportional and PWM Pneumatic Control in Terms of Positioning and Compressed Air Consumption

Abstract

In this paper is shown a comparison of proportional pneumatic control and PWM pneumatic control in terms of positioning and compressed air consumption. All experimental tests were performed on a device for lifting and holding of the workpieces, which consists of one vertically mounted rodless cylinder with integrated vacuum gripper. In the case of the proportional pneumatic control, cylinder piston is always positioning in the correct position, but position losses are recurring during the time (in majority of cases, the position loss is 4 mm). As the control system constantly returns the cylinder piston to the desired position, that increases the compressed air consumption. In the case of the PWM pneumatic control, the position error is occurring (in majority of cases, the absolute value of the relative position error is less than 2%), but there is no position loss during the period of workpiece holding, i.e. there is no additional compressed air consumption. The compressed air consumption differential is approximately 18.6%. In addition, in case of Meter-out control in combination with previously defined types of control, the positioning is more accurate but the compressed air consumption slightly increases with decreasing the opening level of the one-way flow control valve.